Can glass bottles be sterilized by high temperature and reused?

All the disputes that packaging deals with now come together in the post-use treatment. But when dealing with bottles, the accepted question type is undoubtedly far superior to overuse and repeated use. The recycled resources lost by the accepted bottle is smaller than that of using the material to extrude a new bottle. According to the statistical glass bottle data that is well learned in glass packaging, there are about 10% of the bottles are accepted and reused in extrusion molding, which can support the loss of 2-3% of the renewable resources for cooling, and the bottles are accepted for other beneficial cooling resources instead of environmental damage. As everyone knows, the repeated use of the bottle can have a great effect on the cooling cost.
If the bottles of glass bottle manufacturers are sterilized, they can enter the packaging again, and the excess powder is powdered, melted and re-extruded into forming. After all, the selection and acceptance are still used repeatedly. There are many cost and economic benefit factors to be found, and there are many of them in detail. Levels: Does the glass bottle require a deposit to develop the repeated use rate, whether the local turnover material of the wine bottle has a good environment, whether the seller is happy to bear the regulations of repeated use, and whether the mineral water bottle manufacturer is investing in the construction of the same place of sale. The factory conducts repeated canning. If the bottles must be transported wirelessly, the cost is not fair. Is the beverage manufacturer accepting a limited bottle of wine bottle manufacturer body, and whether the opposition parties are related to force the pace.
Although it is right, it is also important to find the hot discussion of consumers, the new policy of the opposition party, the mentality of manufacturers, etc. From the perspective of the team, the repeated use of bottles is the most important rotating tube end for glass bottle manufacturers in the tertiary industry. The drop of the glass from the annealing furnace to the annealing furnace tunnel forms the hanging line of the glass bottle. Compared with the constant flow rate, if the hanging line falls too small, the glass bottle will show an oval shape and harden when it passes through the annealing furnace. To prevent the ovality from exceeding the standard, the temperature in the glass bottle of the muffle furnace is often lowered, so that the surface layer is slightly supercooled, but this often causes irregular fluctuations at the end of the rotating tube, resulting in changes in the diameter and wall thickness of the glass bottle.